CABRIO VINYL COLOR OPTIONS (click on color swatch for a larger view)

Black	Light (Mazda) Tan	Tan

DO YOU NEED A RAIN RAIL?
We recommend replacing the rain rail when you are replacing your convertible top.

We offer both designs either with or without a rain rail.  A rain rail is a U-shaped, molded ABS plastic piece that attaches to the rear bottom of the convertible top.  It directs any water collected out drain holes to keep it from entering your interior cabin and trunk. 
Unless your convertible top is leaking, you probably do not "need" a new rain rail, however, there are good reasons you should consider getting one anyway.

There is a significant amount of time and labor involved to drill out the old rain rail and reinstall it on a new top properly - without any wrinkles.  If you are doing it yourself, and are sure your existing rain rail is in good shape then you can save some money by purchasing a new top without the rain rail.  But, if you are using a professional installer, the amount of additional labor they will charge to do this work will likely offset any savings you have from not buying a new rain rail already installed.


DO YOU NEED NEW TENSION CABLES?
Most likely you will not need to buy new tension cables when replacing your convertible top.

Like most convertible tops, the Miata uses steel tension cables that are threaded into the pockets that run along the side windows.  You can check your existing cables easily. 

With the top up and windows open, run your fingers along the edge of the top until you feel the cable inside edge of the top.  If it feels tight, then it can most likely be reused when you replace your old convertible top.  If it is loose, then it still may just need to be retensioned during the installation of the new top or you may need a new set of spring loaded tension cables. 

An installer may be able to repair damaged tension cables, however if you would like to also replace the tension cables at the same time you replace your convertible top, choose your model year from the accessories to the right.

WINDOW
Includes a new tinted DOT approved glass window with embedded defroster wiring. The window is bonded to the convertible top using an advanced window bonding system that is guaranteed to not fail for 5-years. There is no piping or stitching around the window visible and no unsightly heat-seal press marks.

TOPPING MATERIAL
Manufactured using premium 38 oz. Cabrio Vinyl manufactured by Haartz for that original look and feel. This is the same weight and grain found on the original Miata convertible tops. It is a two-ply composite made of PVC cabrio grain and a cotton lining fabric.

Downloadable installation instructions are available when you purchase online.  These step-by-step instructions cover the entire project, from removing the existing convertible top and installing the new one.

Sample page from the installation manual:


Tools and Materials you May Need Include:

• Phillips Screwdriver
• Drill, steel bit 5/32"
• Ratchet, 10mm socket
• Push-type clip removal tool
• Rivet gun, rivets 1/4"&1/2" 12mm (5/32" 4mm dia.)
• Contact cement spray adhesive (e.g., 3M Super Yellow)