Like most convertible tops, the Miata uses steel tension cables that are threaded into the pockets that run along the side windows.
You can check your existing cables easily. With the top up and windows open, run your fingers along the edge of the top until you feel the cable inside edge of the top. If it feels tight, then it can most likely be reused when you replace your old convertible top. If it is loose, then it still may just need to be retensioned during the installation of the new top or you may need a new set of spring loaded tension cables.
An installer can also repair damaged tension cables, but if you would like to also replace the tension cables at the same time you replace your convertible top, this is the item you need.
The cables worked fine, but were not plastic covered. They were cheaper than other manufacturers, so the cost savings was worth it.
Got these along with my new top just in case the old ones needed to be replaced and they came in handy. They are good quality parts, no ragerts
I was replacing the original top on my 1999 Miata. Replacing the tension cables seemed optional but I’m glad I did. They gave my top a nice tight fit. Excellent company. I would recommend them to everyone.
I replace the original top on my 1999 Mazda Miata. It is at least a 2 day job and at least a 2 person job and it is not the easiest rate 1-10 being the hardest I would say a 8. I order the canvas top and it match up perfectly and looks So good.
I got the new cables when replacing my 20 year old top. They made the installation easier.